Making a EMF-file

[Franklin Demont]

Hello,

I have problems to generate an EMF-file , converting a PDF-File (PDFill Tools) : the result is not good enough , some little characters are not accurate

What is the easiest way to generate an EMF-file ?
Can a EMF-file be edited ? In mine tools (Paint) , the emf-file is read in , but can't be written as emf-file

OR can a EMF-file be avoided ? Maybe using the PDF-file


Frank

[ukoenig]

Maybe getting a better result :

1. You have to install < GHOSTSCRIPT > : http://sourceforge.net/projects/ghostscript/
2. download the Image-editor < XNVIEW from : http://www.xnview.com/en/

after that You can read PDF's with XNIEW and save as EMFor other format



I don't see any difference :




Best regards
Uwe

[Franklin Demont]

Uwe ,

Thanks for the reply , but pdf is not accepted. As described in nview forum i downloaded and installed ghostscript , activated all format's and restartded the computer. No succes.

Could you try ? It is a file from +/- 250000 bytes . I have a email adress from your website.

Frank

[ukoenig]

Frank,

tested again without any problems.
Can You send me the file to
Email : Esckoenig@aol.com

Best regards
Uwe