FiveTech Software tech support forums

... who contain classes, written with FWH. Undeclared identifier 'hb_INITSTATICS" Missing prototype for 'HB_FUNC_INITSTATICS' What's wrong? The errors occur while compiling with xHb 0.99.61 from xHb-march-professionell Regards Frank

Hi James. I think your code is incomplete. :) It may so occur that there are defined two variables TEMP and TMP in environment. For example TEMP=C:\TEMP and TMP=C:\TMP while directory C:\TEMP does not exist but directory C:\TMP does exist. In this case ...

... depend of getN valid/when. For any cause that we couldn't detect pushbutton don't get the focus. We couldn't isolate a little situation when it occur but I detected that it occur only when we use enter key to skip to next control. Using tab key the navigation by the controls, validations and ...

Antonio and All, I have a serious problem with FWH 2.7 (february/2006) and xHarbour from xHarbour.com (february/2006): When I compile my project occur an error: "unresolved external symbol _hb_dynsymSymbol" and I can figure were cause this error. xHarbour.com uses a FiveHCM.lib and FiveHMX.lib. ...

... have just searched all of the message threads for Hernan's Browse and it would appear that when there are FWH and xHB updates problems can and do occur i..e Hernan has to make changes to keep up to date with any FWH and xHB changes or updates. Also - what are you going to do if Hernan decides ...

... after the system is complete, who can they contact to take over the project and continue the work or provide updates. Obviously, should the above occur for any reason, you would negotiate your own rates etc. etc. with the customer. Please send your contact details to me via email. Thanks, Dale. ...

Antonio,
Thank you
fix now with your suggestion.
I use to finish report with
ENDPAGE
ENDPRINT

IF I comment out ENDPAGE, no error.
I confirm that this does not occur since FWH 2.1

... SYMBOL OFF required for huge symbol table ------------------------------------------------------------------------------ This message will only occur with CA-Clipper 5.x Windows programs, and indicates that the symbol table is too large to perform symbol table compression due to limitations ...

... to open it mentionning dbf header is not correct. Once corrected, it shows that 2nd and third are deleted. Richard Forgot to say, execution did occur on pocket pc and file was copied to laptop afterwards

... Just Clipper -> [x]Harbour compatibility. My source code writted in Clipper 5.3b is 235000 lines big. If a bug is not fixed, i am sure it occur in my code. My tests have, and can again, greatly help to increase the reliability of [x]Harbour. Regards, Badara Thiam http://www.icim.fr

I can confirm this behaviour.
It occurs on XP pc's with and without themes.
The problem is that it does not occur allways; I have situations where (on the same object) sometimes the rectangle (visible focus) is present and sometimes not...

Best regards,
Klaas den Dekker