Print Preview support of Duplexing

Print Preview support of Duplexing

Postby byron.hopp » Tue May 30, 2017 3:37 pm

It seems when I developed a printout that prints of both sides of the paper, if I print directly to the printer all is fine and it prints to both sides of the page, but if I print through the Print Preview it then comes out on one side, two pieces of paper. All this assumes that you are using a printer capable of duplexing. Anybody run into this?

Thanks,

Byron Hopp,
Thanks,
Byron Hopp
Matrix Computer Services
byron.hopp
 
Posts: 386
Joined: Sun Nov 06, 2005 3:55 pm
Location: Southern California, USA

Re: Print Preview support of Duplexing

Postby driessen » Tue May 30, 2017 9:46 pm

Byron,

This is the way I solved this problem.

I installed my printer twice.
The first printer is defined to print one sided, the second printer is defined to print duplex.

In the print preview you can change the printer. So you can choose if you want to print duplex from the preview or not.

Good luck.
Regards,

Michel D.
Genk (Belgium)
_____________________________________________________________________________________________
I use : FiveWin for (x)Harbour v. 24.07 - Harbour 3.2.0 (February 2024) - xHarbour Builder (January 2020) - Bcc773
User avatar
driessen
 
Posts: 1422
Joined: Mon Oct 10, 2005 11:26 am
Location: Genk, Belgium

Re: Print Preview support of Duplexing

Postby byron.hopp » Tue May 30, 2017 9:52 pm

Sounds like a good work-around, i'll give it a try.
Thanks,
Byron Hopp
Matrix Computer Services
byron.hopp
 
Posts: 386
Joined: Sun Nov 06, 2005 3:55 pm
Location: Southern California, USA


Return to FiveWin for Harbour/xHarbour

Who is online

Users browsing this forum: dtussman, nageswaragunupudi and 43 guests