Xbrowse : MARQSTYLE_not working with mousewheel

[Marc Venken]

Hello,

In my version 16.11, if I use

:nMarqueeStyle := MARQSTYLE_HIGHLROWMS

The color bar (that is over all the rows) is not folowing the browse when I use the scrollwheel.



You see the bar remains at row 3 and the focus is now on row 5.

Mostly Xbrowse takes care of this, but should I refresh something more ?

[nageswaragunupudi]

Xbrowse : MARQSTYLE_not working with mousewheel

Actually it is working as expected.

Code: Select all  Expand view  RUN

     :nMarqueeStyle := MARQSTYLE_HIGHLROWMS
 

This MarqueeStyle is used for multi-row select. In the above image, blue color row indicates the start row. You can navigate with mouse-wheel to another record far away and use Shift-Click to select from this start row to the current row.

Please use this marquee-style only when required for multi-row selection and not otherwise.

[Marc Venken]

Oeps

I'm actualy using it for multy selection!

I will look into the forum for a sample that will highlight a entire row in the browse while I turn the wheel. Just to see better where I am on the browse.

I don't think that it will give a conflict if there a 2 rowse colored...

Thanks.

[nageswaragunupudi]

Oeps

I'm actualy using it for multy selection!

I will look into the forum for a sample that will highlight a entire row in the browse while I turn the wheel. Just to see better where I am on the browse.

I don't think that it will give a conflict if there a 2 rowse colored...

Thanks.

I explained how we programmed xbrowse.

[JKeutman]

Hallo Marc,

have you found a solution to your problem?
We have the same issue: When using the mousewheel, we often confound the two rows.

Regards, Jeanette

[Marc Venken]

No,

I started living with it

[nageswaragunupudi]

It is not a problem.
This is the intended behavior with a purpose

[Rick Lipkin]

To All

Check the behavior of your mouse wheel in the control panel ( mouse ) .. by default, the mouse wheel scrolls 3 rows.

Rick Lipkin