FiveTech Software tech support forums

by **byte-one** » Wed Dec 19, 2018 10:32 am

As you see, the right end of the browse is not at the end of the area if ::nStretchCol := STRETCHCOL_LAST

if i use ::bClrGrad to paint the header the vertlines are a different from browse and header.

I found also that SetGetColorFocus(nColor) not respected on EDIT_GET and EDIT_GET_LISTBOX!

by **byte-one** » Sat Dec 22, 2018 6:34 pm

Mr. Rao, have you seen this? No good optic for me.

by **byte-one** » Fri Dec 28, 2018 12:10 pm

I found also that SetGetColorFocus(nColor) not respected on EDIT_GET and EDIT_GET_LISTBOX!

by **nageswaragunupudi** » Fri Dec 28, 2018 6:29 pm

byte-one wrote:I found also that SetGetColorFocus(nColor) not respected on EDIT_GET and EDIT_GET_LISTBOX!

We need to set oCol:bClrEdit, which is by default the same as bClrStd.
This is the behavior all these years.

by **nageswaragunupudi** » Fri Dec 28, 2018 6:30 pm

byte-one wrote:Mr. Rao, have you seen this? No good optic for me.

Please give us some more time.

by **byte-one** » Fri Dec 28, 2018 8:05 pm

No problem, my friend!! But the SetGetColorFocus(nColor) was functioning in the past but i dont know what version.

by **nageswaragunupudi** » Fri Dec 28, 2018 8:26 pm

byte-one wrote:But the SetGetColorFocus(nColor) was functioning in the past but i dont know what version.

Then I will check the older versions and get back to you on this.

by **byte-one** » Sat Dec 29, 2018 9:08 am

If using code in this form, the headers, justify and sizes are not respected!

Code: Select all Expand view RUN: REDEFINE COLUMN XBROWSE oList ARRAY aList OF oDlg ID 103 MESSAGE "Liste" ; HEADERS {"Datum","Buchungstext","Betrag","Beleg"} ; JUSTIFY {AL_CENTER,AL_CENTER,AL_CENTER,AL_CENTER} ; SIZES {100,190,60}

Only when i add COLS {1,2,3,4} all is functioning. But this should not required as in this case the natural order of the array should be used!

XBROWSE Facelifting and another behavior!