TButton Icon Alignment

[Rick Lipkin]

To All

I have 4 identical sized TButtons 52 x 20 that each have a 16 bit icon .. I can not ( further ) change the width of the Button Prompts ..



Notice how the second button Icon is out of alignment .. Here is the code .. I realize the length of the Prompt is longer than the other 3 and seems to push the icon farther left .. There is plenty of room if there was a way to insert a space to right pad the icon to line up all 4 icons ..

Please note that I continue to widen the button with very little changes in the calculation placement of the icon .. any help would be appreciated.

Thanks
Rick Lipkin

Code: Select all  Expand view  RUN

REDEFINE BTNBMP oBtn2 ID 252 OF oGrps   ;
         RESOURCE "COMMENT" ;
         PROMPT "Comment" LEFT 2007;
         ACTION ( _ViewMemo2( cMode, oRsTrav, "Request",oBtn1,oBtn2,oBtn3,oBtn4,oBtn5, "2" ,@cComments, 400, cPrevAppr, oFontb ),LightGreyGrad());
         GRADIENT GreyButtonGrad()
 

[Rick Lipkin]

Any news ??

Thanks
Rick Lipkin

[nageswaragunupudi]

For the purpose of testing, can you change the prompt as "abc" (shorter text) ?

[Rick Lipkin]

Rao

Using a fixed length Prompt "Abc" does make all the button icons line up correctly .. unfortunitly, not all captions will have the same length...



It would be nice if you could add a space before the Resource to be able to force the icon to the right to correct the spacing when needed ..

Code: Select all  Expand view  RUN

REDEFINE BTNBMP oBtn2 ID 252 OF oGrps   ;
         RESOURCE space(1)+"COMMENT" ;
         PROMPT "Comment" LEFT 2007;
         ACTION ( _ViewMemo2( cMode, oRsTrav, "Request",oBtn1,oBtn2,oBtn3,oBtn4,oBtn5, "2" ,@cComments, 400, cPrevAppr, oFontb ),LightGreyGrad());
         GRADIENT GreyButtonGrad()
 

Rick Lipkin

[nageswaragunupudi]

Then you need to increase the width of the buttons to provide enough room to accommodate both bitmap and the prompt.

[Rick Lipkin]

Rao

I realized that .. was hoping for another possible solution .. This form is quite complex and there is just no room to enlarge the buttons ....



Rick Lipkin

[nageswaragunupudi]

Try specifying oBtn:aBmpRect := { t, l, b, r } in pixels.
Then bitmap will be positioned inside the specified rectangle.
Specify the same rect to all the buttons.