To Nages

[Silvio]

Dear Mr Rao,
I try to insert bitmaps on xbrowse but it not run ok
I sent you all the test files , can you see this error please ?

[nageswaragunupudi]

Mr Silvio

I have seen your code. Please make the following changes.
For the line:

Code: Select all  Expand view

      AAdd(aGradiBmp, oDTipGrad->Bitmap )
 

substitute

Code: Select all  Expand view

      AAdd(aGradiBmp, Trim( oDTipGrad->Bitmap) )
 

If you are using 10.8 or later

Code: Select all  Expand view

oCol:AddBitmap( aGradiBmp )

works.
But if you are using 10.7 or earlier, please load bitmaps in a loop

Code: Select all  Expand view

for n := 1 to Len( aGradiBmp )
oCol:AddBitmap( aGradiBmp[ n ] )
next

[Silvio]

Now run on old Fwh08.10 but I must see this afternoon on 09

but this command not run ok

oApp():oGrid:nRowHeight := 40

you change also the height of row of xbrowse ?

[nageswaragunupudi]

The only issue is Trim(...)

I did not make any other changes

[Silvio]

look please



I made :
oApp():oGrid:nRowHeight := 50 //90 // 120 not run this
oApp():oGrid:nHeaderHeight := 36

[Otto]

Maybe some of the officers (Salvatori 5 stars) are too much decorated?

Best regards,
Otto

[Silvio]

ja jajajajajja
Otto,
it is a Rescue Association (volunteer rescue).... Red Cross also

[nageswaragunupudi]

Mr. Silvio

It is better you do not specify the row height and allow xbrowse to calculate the row height.

Most of the times we get better results if we let xbrowse do its job on its own.

[Silvio]

Rao now run ok
there is an error on xbrowse state , i erase it and now run ok sorry