Me ha costado lo mio , hasta que al alzar la vista he visto la doble definición
Supongo que está corregido en otras versiones, pero lo comento por si alguien le pasa lo mismo.
- Code: Select all Expand view RUN
- #ifdef __HARBOUR__
#ifdef __XHARBOUR__
#ifndef __64__
#define FWVERSION "FWHX 10.8"
#define FWDESCRIPTION "FiveWin for xHarbour"
#else
#define FWVERSION "FWHX64 10.8"
#define FWDESCRIPTION "FiveWin for xHarbour 64"
#endif
#else
#ifndef __64__
#define FWVERSION "FWH 10.8"
#define FWDESCRIPTION "FiveWin for Harbour"
#else
#define FWVERSION "FWH64 10.8"
#define FWDESCRIPTION "FiveWin for Harbour 64"
#endif
#endif
#xtranslate Browse( => WBrowse( // to avoid conflicts with Harbour functions
#xtranslate SetCursor( => WSetCursor( // to avoid conflicts with Harbour functions
#xtranslate __Keyboard( => ___Keyboard( // to avoid conflicts with Harbour functions
#xtranslate LastKey( => _LastKey( // to avoid conflicts with Harbour functions
/* TRY / CATCH / FINALLY / END */
// ESTO ROMPE XHARBOUR.. CREO QUE TENDRIA QUE ESTAR FUERA
* #xcommand TRY => BEGIN SEQUENCE WITH {| oErr | Break( oErr ) }
* #xcommand CATCH [<!oErr!>] => RECOVER [USING <oErr>] <-oErr->
* #xcommand FINALLY => ALWAYS
#endif
#ifdef __FIVESCRIPT__
#undef __HARBOUR__
#endif
#ifdef __HARBOUR__
#ifndef __XHARBOUR__
/* static bError
#xcommand TRY => bError := errorBlock( {|oErr| break( oErr ) } ) ;;
BEGIN SEQUENCE
#xcommand CATCH [<!oErr!>] => errorBlock( bError ) ;;
RECOVER [USING <oErr>] <-oErr-> ;;
errorBlock( bError )
*/
#xcommand TRY => BEGIN SEQUENCE WITH {|oErr| Break( oErr )}
#xcommand CATCH [<!oErr!>] => RECOVER [USING <oErr>] <-oErr->
#xcommand FINALLY => ALWAYS
#xtranslate hb_ReadIni([<x,...>]) => hb_IniRead(<x>)
#xtranslate HASH([<x,...>]) => hb_HASH(<x>)
#xtranslate HGETPOS([<x,...>]) => hb_HPOS(<x>)
#xtranslate HSET([<x,...>]) => hb_HSET(<x>)
#xtranslate HSETCASEMATCH([<x,...>]) => hb_HSETCASEMATCH(<x>)
#xtranslate HCLONE([<x,...>]) => hb_HCLONE(<x>)
#xtranslate HGETKEYS([<x,...>]) => hb_HKEYS(<x>)
#endif
#endif
